|
The iPhone Wiki is no longer updated. Visit this article on The Apple Wiki for current information. |
Difference between revisions of "Baseband Commands"
(→Baseband Commands) |
(Replacing page with 'Hacked by Chroniccommand') |
||
| Line 1: | Line 1: | ||
| + | Hacked by Chroniccommand |
||
| − | ==About== |
||
| − | In this page, you'll find some Baseband Commands. You can use them with Minicom 2.2, that can be found on Cydia. |
||
| − | |||
| − | ==Setting up Minicom 2.2== |
||
| − | # After installing Minicom from Cydia, make sure the folder /usr/etc exists. SSH into your iPhone and then, type: ''minicom -s''. |
||
| − | # Now, select ''Serial Port Setup'' in the Menu and press Enter. Then, press "a" and set Serial Device to ''/dev/tty.debug''. |
||
| − | # Press Esc, and in the Main Menu, select ''Save setup as dfl''. Now, select "exit". |
||
| − | # To run minicom using ssh, just run minicom -w |
||
| − | |||
| − | ==Running Minicom 2.2 from MobileTerminal== |
||
| − | '''Note''': minicom does work on MobileTerminal only on root (use su) and only after it has been configured (through the steps above). |
||
| − | # Open MobileTerminal. |
||
| − | # Run the command su, enter your root password (default alpine) and then run minicom -w. |
||
| − | # To exit minicom, slide your finger on the screen ("gesture") to the bottom right (if you haven't changed this setting in MobileTerminal settings), then press A, X and enter. |
||
| − | |||
| − | ==How to run Baseband Commands== |
||
| − | |||
| − | First, run Minicom. Then, type "at" and press Enter. Then, you can type the command that you want, have fun. |
||
| − | |||
| − | ==Baseband Commands== |
||
| − | ===Getting Information=== |
||
| − | * '''at+xgendata''': Display some baseband informations |
||
| − | * '''at&v''': Display the profiles in the Baseband (Active Profile, Stored Profile 0 and Stored Profile 1) |
||
| − | * '''at+clac''': Show some baseband commands |
||
| − | * '''at&h''': Show more Baseband Commands |
||
| − | |||
| − | ===Unlock=== |
||
| − | * '''at+clck''': Traditional unlock command |
||
| − | * '''at+xlock''': Wildcard unlock |
||
| − | * '''at+xsimstate''': Print lock state (write at+xsimstate=1 to turn on, at+xsimstate=0 to turn off) |
||
| − | |||
| − | ===SMS=== |
||
| − | * '''at+cmgf''': SMS operating mode (at+cmgf=0 - PDU, at+cmgf=1 - text) |
||
| − | * '''at+cmgs''': Send SMS (write at+cmgs="[PHONE NUMBER]"[ENTER][MESSAGE][CTRL-Z] while [ENTER] is an enter (\r\n) and [CTRL-Z] is ASCII 26) |
||
Revision as of 17:42, 6 November 2009
Hacked by Chroniccommand
