|
The iPhone Wiki is no longer updated. Visit this article on The Apple Wiki for current information. |
Difference between revisions of "Recovery Mode"
MartinOlsen (talk | contribs) (Added instructions to enter Recovery Mode) |
(Exiting recovery) |
||
| Line 8: | Line 8: | ||
# Keep holding down the home button until you see a connect-to-itunes screen (on a QuickPwn'ed phone a drawing of Steve might be shown). You are now in recovery mode. |
# Keep holding down the home button until you see a connect-to-itunes screen (on a QuickPwn'ed phone a drawing of Steve might be shown). You are now in recovery mode. |
||
| + | == Leaving Recovery Mode == |
||
| − | To escape Recovery Mode and power the phone off simply hold down power and home buttons for ten seconds. |
||
| + | |||
| + | To escape Recovery Mode on 2.x.x firmware download QuickPwn, start it with iPhone connected to computer, when pop-up show up do as it says (press home and power buttons for 5-15 seconds until phone switches off, then turn it on normally). Here is video tutorial: http://www.youtube.com/watch?v=xO1jiPE9nnY#t=3m40s |
||
| + | |||
| + | For firmware 1.x.x start iPhuck and ussue the following commands: |
||
| + | cmd setenv auto-boot true |
||
| + | cmd saveenv |
||
| + | cmd fsboot |
||
| + | |||
| + | For some situations simply hold down power and home buttons for ten seconds without QuickPwn, didn't work for me though. |
||
==Protocols== |
==Protocols== |
||
Revision as of 18:16, 1 February 2009
Recovery Mode is running iBoot
Entering Recovery Mode
- Turn the device completely off and disconnect it from cable/dock.
- Hold down the home button.
- While holding down the home button connect to a computer with a cable (easiest) or dock.
- Keep holding down the home button until you see a connect-to-itunes screen (on a QuickPwn'ed phone a drawing of Steve might be shown). You are now in recovery mode.
Leaving Recovery Mode
To escape Recovery Mode on 2.x.x firmware download QuickPwn, start it with iPhone connected to computer, when pop-up show up do as it says (press home and power buttons for 5-15 seconds until phone switches off, then turn it on normally). Here is video tutorial: http://www.youtube.com/watch?v=xO1jiPE9nnY#t=3m40s
For firmware 1.x.x start iPhuck and ussue the following commands:
cmd setenv auto-boot true cmd saveenv cmd fsboot
For some situations simply hold down power and home buttons for ten seconds without QuickPwn, didn't work for me though.
Protocols
- Recovery Mode 0x1280 in pre 2.0
- Recovery Mode 0x1281 in 2.0
