|
The iPhone Wiki is no longer updated. Visit this article on The Apple Wiki for current information. |
Difference between revisions of "Diags (iBoot command)"
MuscleNerd (talk | contribs) |
ChronicDev (talk | contribs) (→Exploit) |
||
| Line 5: | Line 5: | ||
==Exploit== |
==Exploit== |
||
| − | This is a very simple exploit. In earlier iBoots, if a parameter was given to the 'diags' command, then it would jump to whatever address argv[1] specified, but not before disabling the GPIO devices. You can run unsigned code on the |
+ | This is a very simple exploit. In earlier iBoots, if a parameter was given to the 'diags' command, then it would jump to whatever address argv[1] specified, but not before disabling the GPIO devices. You can run unsigned code on the S5L using this, but the GPIOs need to be restored if you intend to use any I/O again (such as the screen or serial or USB). |
| − | In 2.0 iBoots, they |
+ | In 2.0 iBoots, they have a flag check on this command (checks bit 4 of the iBoot flags), and that flag will not be present on a retail device, just an engineering one with a 'whitelisted' CHIPID, so this exploit doesn't work. |
[[Category:Jailbreaks]] |
[[Category:Jailbreaks]] |
||
Revision as of 11:34, 11 December 2008
This was an exploit in pre 2.0 versions of iBoot
Credit
Exploit
This is a very simple exploit. In earlier iBoots, if a parameter was given to the 'diags' command, then it would jump to whatever address argv[1] specified, but not before disabling the GPIO devices. You can run unsigned code on the S5L using this, but the GPIOs need to be restored if you intend to use any I/O again (such as the screen or serial or USB).
In 2.0 iBoots, they have a flag check on this command (checks bit 4 of the iBoot flags), and that flag will not be present on a retail device, just an engineering one with a 'whitelisted' CHIPID, so this exploit doesn't work.
