Baseband Commands

About

In this page, you'll find some Baseband Commands. You can use them with Minicom 2.2, that can be found on Cydia.

Setting up Minicom 2.2

1. After installing Minicom from Cydia, make sure the folder /usr/etc exists. SSH into your iPhone and then, type: minicom -s.
2. Now, select Serial Port Setup in the Menu and press Enter. Then, press "a" and set Serial Device to /dev/tty.debug.
3. Press Esc, and in the Main Menu, select Save setup as dfl. Now, select "exit".
   • Note: minicom does work on MobileTerminal only on root (use su) and only after it has been configured.
4. Run the command su, enter your root password (default alpine) and then run minicom -w.
5. To exit minicom, slide your finger on the screen ("gesture") to the bottom right (if you haven't changed this setting in MobileTerminal settings), then press A, X and enter.

Running Minicom

To run minicom, is pretty simple: just type "minicom -w".

How to run Baseband Commands

Here is the list that me (pH) and EvilPenguin are doing of Baseband Commands.

First, run Minicom. Then, type "at" and press Enter. Then, you can type the command that you want, have fun.

Baseband Commands

Getting Information

at+xgendata: Display some baseband informations

at&v: Display the profiles in the Baseband (Active Profile, Stored Profile 0 and Stored Profile 1)

at+clac: Show some baseband commands

at&h: Show more Baseband Commands

Unlock

at+clck: Traditional unlock command

at+xlock: Wildcard unlock

at+xsimstate: Print lock state (write at+xsimstate=1 to turn on, at+xsimstate=0 to turn off)